Infinity Wakeboard Tower Sound System 2100m Manual do Utilizador descarregar pdf (Página 8)

Infinity S

ystems, 250 Crossw

ays P

ark Drive, Woodbury, NY 11797 USA

6.67

4.4INF (4463) • F

AX 51

6.682.3556 • www

.infinitysystems.com

Infinity is a registered trademark, and CMMD is a trademark, of Harman International Industries, Incorporated.

CMMD patent nos. 6,327,372 and 6,404,897.

t No. 6100MOM6/04 • Printed 6/04

•

PROBLEM:

No audio (blue LED off, red LED flashing).**

CAUSE and SOLUTION:

1. Thermal protection.

– Turn the system off and allow the amplifier

to cool off.

•

PROBLEM:

Distorted audio (blue LED on, red LED off).

CAUSES and SOLUTIONS:

1. Gain control is set too high, or amplifier or

source unit is defective.

– Check gain setting.

– Source unit output is distorted.

2. Short circuit in speaker wires.

– Check speaker wires for shorts or grounds.

•

PROBLEM:

Music lacks punch.

CAUSE and SOLUTION:

1. Speakers are not connected properly.

– Check speaker connections for proper

polarity.

SPECIFICATIONS

6100m

• 125W x 2 ch.

• Frequency Response: 10Hz – 40kHz

• Signal-to-Noise Ratio: 91dB

• Line-Level Input Sensitivity: 250mV – 6V

• Speaker-Level Input Sensitivity: 6V – 16V

• Speakers: 11" x 18" x 14-1/2"

• Amplifier: 8-1/8" x 8" x 2-3/8"

• Microphone: 1-1/4" x 2-1/2" x 3-5/8"

• Min. Speaker Impedance: 4 ohms, stereo

6000m

• Power Handling: 150W

• Peak Power Handling: 450W

• Sensitivity: 93dB @ 2.83V

• Frequency Response: 80Hz – 20kHz

• Impedance: 4 ohms

• Polypropylene Cone

• Cast-Polymer Basket

• CMMD

™

Tweeter

• Rubber Surrounds

• UV-Resistant

• Water-Resistant

• Salt-Spray-Resistant

• 11" x 18" x 14-1/2"

2100m

• 125W x 2 ch. @ 4 ohms

• 150W x 2 ch. @ 2 ohms

• 250W x 1 ch. @ 4 ohms

• Frequency Response: 10Hz – 40kHz

• Signal-to-Noise Ratio: 91dB

• Line-Level Input Sensitivity: 250mV – 6V

• Speaker-Level Input Sensitivity: 6V – 16V

• 8-1/8" x 8" x 2-3/8"

• Min. Speaker Impedance: 2 ohms, stereo

4 ohms, bridged

•

PROBLEM:

No audio from page.

CAUSES and SOLUTIONS:

1. Microphone is not connected properly.

– Check microphone connections.

2. Page level set to minimum.

– Check level control on microphone.

•

PROBLEM:

Page is distorted.

CAUSES and SOLUTIONS:

1. Page level is too high.

– Reduce page level.

2. Shouting into microphone.

– Hold microphone away from face.

•

PROBLEM:

Feedback.

CAUSES and SOLUTIONS:

1. Squealing sound from the speakers when

using the Paging system.

– Reduce page level on microphone.

– Increase distance between microphone

and mouth while speaking.

Features, specifications and appearance are subject to change without notice.

•

PROBLEM:

No audio (POWER LEDs are off).

CAUSES and SOLUTIONS:

1. No voltage at Batt + or remote terminal.

– Check all power connections with a VOM.

2. Poor ground connection.

– Check fuses.

3. Microphone power switch is off.

– Check power switch on Mic.

•

PROBLEM:

No audio (POWER LEDs are on).

CAUSE and SOLUTIONS:

1. No input signal or no speaker signal.

– Check all input connections from source unit.

– Check all speaker connections.

– Check fader control on head unit.

•

PROBLEM:

No audio (blue LED on – red LED flashing).**

CAUSES and SOLUTIONS:

1. Over or under voltage.

– Battery voltage above 16 volts or below

10 volts. Check battery and charging system

for proper operation.

2. Shorted output.

– Check speaker connections and wires.

** NOTE: The microphone has a blue power LED

and the amplifier has a red power LED.

TROUBLESHOOTING

1 2 3 4 5 6 7 8

Comentários a estes Manuais

Sem comentários

Infinity Wakeboard Tower Sound System 2100m Manual do Utilizador Página 8

Comentários a estes Manuais

Manuais e produtos relacionados com Acústica Infinity Wakeboard Tower Sound System 2100m